A two part Epoxy glue or Foam safe super glue. (CA glue).
This is can be easily fixed using a piece of tape, the best tape
to use is Gaffer tape. Never fly with a wing that has a crease
line on it, this is the point in which the wing could fold in
flight, causing the model to crash.
P-51, FW190, Super Cub. Lack of motor power or forward thrust.
Main battery not charged fully
Motor pinion slipping
Charge main battery
Replace motor pinion
P-51 FW190 F27B. The plane noses to the ground from launch
Bad hand launch
No throttle applied
Tail control surfaces out of alignment
Always hand launch in a level plane
Launch with a reasonable amount of forward momentum
Use a throttle setting of around ¾ to full throttle
Set the tail control surface to have around 1mm of up movement
P-51 FW190 F27B. The plane constantly turns to the left or right
The aileron control surface out of trim
Wind gusty or too strong
Position the aileron trim on the transmitter to the centre then re
align the aileron control surfaces to be level with the trailing
(rear) edge of the wing.
Fly in less windy conditions
|