Wingspan:	385mm (15.2 in)
Wing Area:	25.5 sq dm (87.5 sq in)
Length:	445mm (17.5 in)
Weight without Battery:	31.0 g (1.10 oz)
Weight with Li-Po Battery:	35.5 g (1.25 oz)
Motor:	8.5mm coreless brushed (installed)
Receiver:	Spektrum AR6400L Ultra-MicroReceiver/ESC/Servo unit (pre-installed)
Servos:	Elevator and Rudder servos integrated on the AR6400L with two independent Spektrum AS2000L Ultra-Micro long-throw aileron servos (pre-installed)

2-150mAh 3.7V Li-Po batteries
Very light 30 gram weight capable of flying in
smaller areas
4 channel fully proportional control
Full 3D aerobatic capability
Celectra 4-Port 1-cell Li-Po Charger and
AC adapter included
Charge four batteries at once at home or at
the flying venue
DSM2 technology will work with all DSM2
transmitters
Everything except Transmitter included
No building required just bind and fly
Quick and easy to get in the air
Bright high visibility colour scheme
Real “Depron” construction for strength
and durability
Two independent aileron servos included
for better control response

EFL9051	Prop with Spinner (2)
EFL9052	Main Motor
EFL9053	Gearbox with Motor Shaft
EFL9054	Prop Shaft with Gear (2)
EFL9055	Landing Gear Set with Mounts
EFL9056	Pushrod Set
EFL9057	Hardware Set
EFL9061	Wing Carbon Rods & Support Bracing
Optional Parts
EFLB1501S	1S 3.7V 150mAh Li-Po Battery
PKZ3052	Battery Connector with Wire

EFL9080i Ultra Micro 4-Site BNF

The 4-Site Bind and Fly comes completely assembled with a Spektrum AR6400L Ultra-Micro DSM2 receiver/ESC/Servo unit that features two built-in linear long-throw servos for the elevator and rudder, and these along with the two independent long-throw Spektrum AS2000L Ultra-Micro servos on the ailerons provides great 3D performance.

Also included are two 1S 3.7Volt 150mAh Li-Po battery packs as well as E-flite’s Celectra 4-Port Li-Po charger and AC adapter that allows you to charge up to four 1S Li-Po packs at once enabling you to charge batteries while you fly. This convenient charger may be powered by either D cell batteries or with the included AC adaptor, charging the 110mAh Li-Po batteries in about 20 minutes.

The Micro 4-Site is finished with a pre-printed high visibility colour scheme with no additional building or assembly is required, simply bind to your DSM2 aircraft transmitter and fly.
The model has fully proportional 4-channel control of throttle, rudder, elevator and ailerons, with a state of the art 6-channel Spektrum receiver, ESC, and two individual aileron servos for maximum control.

This combination of low weight, technology and design will now bring extreme 3D flight conveniently into smaller venues than previously possible, and experienced pilots will be capable of flying the Micro 4-Site in a large living room or small sports halls.

This is one model that can certainly turn heads at any indoor venue with its outrageous flight performance!